OXIDATION STABILITY - RPVOT / RBOT / TFOUT
ASTM D2112, D2272, D4742, D7098; IP 229

DRY BATH

Features:

  • Benchtop automatic equipment

  • Magnetic contactless stirrer for rotation.

  • Dry heating block

  • Stainless steel dry vessel

  • Touch screen interface to set test parameters, run test, store results, diagnostics & calibration routines. Real time pressure & temperature data acquisition. Graph plotting of pressure and temperature

  • Automatic oxygen charge/discharge (manual charging also available)

  • Automatic oxygen purging prior test

  • Automatic rapid cooling system after test completion

Safety:

  • Dry heating block eliminates the hazards and fumes generated by heating oils

  • Odors venting through tubing to scrubber or vent

  • Emergency shutdown button

  • Over temperature and over pressure cut-off

Specifications:

TEMPERATURE RANGE : Ambient to 170°C

TEMPERATURE STABILITY : ±0.001°C

DISPLAY RESOLUTION : 0.1°C

TIMER : 0.1 s

ROTATION : Magnetic contactless stirrer

BATH TYPE : Dry heating block

AIR REGULATION : Automatic regulation using mass flow controllers

AIR FLOW RANGE : 0 to 1200 ml/hr with precision 0.1% f.s.

LIQUID BATH

Features:

  • Benchtop automatic twin-unit equipment with two independent motors for the rotation of vessels.

  • Vessels are equipped with electronic pressure transducers, cables and quick connectors,

  • Enamel finished steel case, benchtop version.

  • Stainless steel tank. Capacity: 70 liters.

  • Stainless steel top cover.

  • One support rack for the vessels.

  • Electric stirrer to ensure temperature uniformity.

  • Microprocessor controlled thermoregulator with PID action and built-in digital display 0.1 °C accuracy. Probe: Pt100 RTD. Working range: from ambient to 170°C. Regulation accuracy: ± 0.1°C.

  • Stainless steel heaters, SSR controlled.

  • Independent motor for each vessel, inverter controlled.

  • Safety devices against overheating and low level.

  • 8.4” touch screen interface that permits to control the instruments, start tests, show pressure and temperature on a graph, save and retry data, perform diagnostic and calibration. Pressure can be shown both in kPa or psi.

  • N° 2 USB + n° 1 Ethernet + n° 1 RS-232 ports for connection to printers, network etc.

  • For 220 V/50 Hz connections: 4000 W power

  • CE marked.